512-255-7633

SP2000LX 96V / 48V

The LX Series are advanced UPS that provide clean, regulated dual conversion power for controllers and other sensitive equipment inside the traffic cabinet.

Product Specifications

Voltage 75 VAC to 155 VAC (before going to batteries)
Frequency 45 Hz to 65 Hz
Voltage 120 VAC ±3%
Frequency 50 Hz or 60 Hz
Current 16.7 A
Rating 2000 VA / 1400 W
Crest Factor Ratio 50% load up to 4.8:1, 75% load up to 3.2:1, 100% load up to 2.4:1
THD 4.00% maximum
Dynamic Response ±4% for 100% step load change 0.5 ms recovery time
Overload 110% for 10 sec; 200% for 50 ms
UPS Protection Input and output short circuit, Input and output overload, Excessive battery discharge
Temperature -40°C to +74°C (-40°F to +165°F)
Humidity 0% to 95% non-condensing
Altitude Sea level to 10,000 ft
Input Hardwired to bypass box
Outputs Hardwired to bypass box, with single 15 Amp receptacle
Dimensions
H x W x D (in)
3.5 x 19.0 x 10.0 (2U)
Weight (lb) 13
Cooling Low velocity, Forced air
Standard Features Power factor corrected input, Fully regenerative, True on-line continuous power, Low distortion sine wave output, Designed for non-linear loads, Extended brownout protection, EIA/RS232 data interface, 96 VDC battery system
Certifications IEEE 587/ANSI C62.4, IEC 555 @ 120 VA, NEMA
Typical Recharge Time
(to 85% Capacity @ 100% Load)
48-72 hrs (more time required with extended battery option)
Switches / Control Panel System power, Cold start, Test, Alarm silence, Four line LCD display panel
Audible Alarms Utility interrupt, Inverter failure, Overload, Low battery, Self test
Intelligent Computer Interfaces Serial interface for EIA 232, 1 each DB9-F (RS232 and signal interface pins) and 1 each USB, Full interactive remote computer monitoring and control of most features including load control (requires optional monitoring software), NTCIP and TCP/IP ready
Contact Closures “D” connector, Open collector (see user manual for additional interface information)
SNMP Interface Allows full control and monitoring interface over network connection. Compatible with HP Openview™, IBM Netview™, CA Unicenter TNG™, and other major software offerings.
Battery Bus Voltage 96 V or 48 V